Story TrailerHookup created by Michael Newman |
Show the sequence of steps to hookup a horse trailer.
|
Start with the trailer directly over the ball. The sleeve must be retracted so the hitch is open. Lower the hitch onto the ball.
Close the sleeve by squeezing in the locking clamp and if necessary manipulating the lever.
Insert the locking pin.
Insert the electrical plug.
Run the thin wire through a loop on the truck and connect it to the carabiner. Do nor remove the carabiner, just insert or remove the loop at the end of the wire.
Completed hookup.
Other photos taken at the same time that these photos were taken can be found in the directories that these photos came from. The photos in this story came from the following directories:
bydate/2013q3q4
|